Drying tables

Drying tables are designed to remove moisture from the surfaces of parts placed in the zone of drainage in bulk. This device allows you to drain parts of small dimensions processed in drums, bells and so on.

The advantages of the drying tables produced by Poliplast Ltd.:

• Easy loading/unloading
• Ability to load/unload manually or using hoist
• High speed of output at working temperature in parallel with decreasing power of electric heaters
• "Soft" heating of the parts
• No direct contact with the heating element
• Drainage parts in bulk
• Direct contact of employee with drained products
• No direct contact with the heating element
• Low noise level during operation of the installation (the use of high quality fans)
• Simple design provides high reliability of the equipment
• Energy saving due to optimization of installation options
• System of control and regulation of operating temperature
• In cases where the drying table united with the position of loading/unloading, it is possible to add and install the mechanism of lifting countertops

Standard equipment

• Carbon steel body, lined with stainless steel
• Thermal insulation
• Integrated support frame with adjustable feet
• High quality finish is chemical-resistant enamel
• Heater or heat exchanger
• The blower motor, mounted on anti-vibration mount
• Temperature sensor for intake air
• Protection sensor against overheating of electric heaters
• Pressure sensor of air flow
• Control system
• The working surface of the table can be made of a perforated sheet, or a sheet with a mesh laid on it with the desired cell size

Optional extra

• Bracket for placing parts on the suspension
• Lighting element above working area
• Automatic unloading system
• Side exhaust to accelerate the output to the set heating temperature in parallel with the reduction in the power of electric heaters
• Mechanism of lifting the table top